![]() Also note that the connector on the left side (BMW side) has the brown wire in the #1 position on the outside. Connect remaining 3-pin connector, verify connections are snug. Connect 6-pin connector to DICE harness, this is keyed to only go in one direction.ġ3. Unwrap cloth sheath to expose needed 3-pin and 6-pin CD Changer connectors.ġ2. CD Changer wiring located, wrapped in cloth sheath.ġ1. This will have the needed 3-pin and 6-pin connectors.ġ0. This will be located behind the factory amplifer touching the inner wall of the fender. ![]() Location of 2nd expansion rivet, this will need to be removed.ĩ. There are (2) rivets that will need to be removed to gain access to the wiring.ħ. Remove expansion rivet with a trim removal tool or similiar device. Image of taillight with housing removed.Ħ. Remove inner taillight housing and taillight plug.ĥ. e46 radios will not need a radio code when connected.Ĥ. ![]() Remove fuses #7 & #41 to cut power to the radio/navigation tuner. Access the fuse panel in the glovebox by turning the nylong retaining clips inward 90 degrees until the panel drops down. This will unclip or unscrew depending on your specific model year.ģ. ![]() The driver’s side rear taillight house will need to be removed. The needed connections will be in the trunk/boot area.Ģ. This is a typical glovebox installation, which allows a clean stealth install with no drilling any damage to the vehicle.ġ. We are going to focus more on the install aspects rather than operation to keep the post length to a minimum. The vehicle was ordered without a CD Changer.įirst, the DICE iPod kit comes with 3 major pieces: In this DIY, we are going to install a DICE iPod integration kit into a 2005 330Ci with Business CD and rear fold down seats. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |